SEAMETRICS EX-100 SERIES - INSERTION ELECTROMAGNETIC FLOW METER

Depth adjustable sensors

EX110 fits any 1-1/2" pipe fitting (standard saddle, for instance) and adjusts to pipe sizes 3-10"

EX210 adjusts to pipe sizes 10-48"

Meter extends only about 1/8 of pipe diameter, minimizing potential for clogging with debris
Accept Seametrics modules for rate and total indication, 4-20 mA conversion, data logging, and flow switching
Alternatively, signal can be sent directly to a PLC or other control
Available in brass or 316 stainless steel
Immersibility and reverse flow output available

The complete lack of moving parts of the EX100/200-Series insertion fow sensor is the source of its reliability. Brass and
stainless steel models withstand a variety of temperature, pressure, and chemical conditions. The EX-Series has no rotor to stop turning in dirty water and there are no bearings to wear out. Like all magmeters, when used in chemical injection applications, these meters should be installed upstream of the chemical line (or far enough downstream to allow complete mixing of fuids before the meter).

A rapidly reversing magnetic feld is produced in the lower housing. As the fuid moves through this feld, a voltage is generated that is measured and translated into a frequency signal proportional to fow rate. This square wave signal can be sent directly to a PLC or other control or can be converted using any of the Seametrics family of indicators and converters.A modular system of electronics can be attached directly to the fow sensor or remotely mounted. The Seametrics FT420 provides full indication of rate and total, plus 4-20 mA output. The AO55 provides blind 4-20 mA output, and the DL76 is a battery-powered data logger.
The adapter ftting of the EX sensor is standard male NPT, and can be directly threaded into ordinary saddles or threaded weld fttings. The EX115 and 215 include an isolation valve, allowing hot-tap installation, or installation and removal under pressure; a bronze ball valve is standard, with a 316 stainless steel valve option if needed.Reverse fow output and immersibility are optional.

FEATURES
• No moving parts
• Durable
• Adjustable depth
• Hot-tap available
• Brass or stainless steel
• Immersibility available
• Reverse fow output available

APPLICATIONS
• 3”- 48” pipe (up to 72” optional)
• Clean or “dirty” liquids
• Conductive liquids
• Municipal
• Industrial
• Irrigation


Kembali ke halaman sebelumnya



http://wmaflow.com/seametrics/ex100.html